Submit measurement report on individual measurements of air pollutants in medium-sized combustion plants

• You contact an accredited measuring institute or an expert, provide the necessary information for the measurement and arrange a measurement date.
• The measuring institute or expert prepares the measurement plan for you and reports it to the immission control authority responsible for you together with the measurement date.
• On the measurement date, the measuring institute or expert determines the emission values on your premises and compares them with the legally prescribed emission values for your plant.
• Once the measurements have been completed, you will receive a measurement report from the measuring institute or expert.
• You check the measurement report and send it together with the measurement planning, the results of the measurements, the measurement method used and the operating conditions during the measurement to the immission control authority responsible for you.
• You will then receive confirmation from the authority that your measurement report has been received.

If you wish to have the individual measurements carried out for a combustion plant that does not require a permit and has a rated thermal input of less than 10 megawatts:

• You can also have the measurements carried out by a chimney sweep instead of a measuring institute or an expert.
• The remaining steps correspond to the procedure described above.

Please contact the responsible structural and licensing directorate.

• You are the operator of a medium-sized combustion, gas turbine or internal combustion engine plant.
• You have commissioned your plant or made emission-relevant changes.

Complete measurement report with details of:

• Measurement planning
• measurement result
• Measurement methods used
• Operating conditions that are important for the assessment of the measurement results

If you operate a combustion system that does not require a permit with a rated thermal input of less than 10 megawatts and the measurement was carried out by a chimney sweep:

• Certificate from the chimney sweep about the measurement

Complete measurement report with details of:

• Measurement planning
• measurement result
• Measurement methods used
• Operating conditions that are important for the assessment of the measurement results

If you operate a combustion plant that does not require a permit with a rated thermal input of less than 10 megawatts and the measurement was carried out by a chimney sweep:

• Certificate from the chimney sweep about the measurement

In any case, you must have the measurements carried out within 4 months of commissioning the system or any other emission-relevant change.

You must submit the measurement report or certificate to the competent authority without delay.

There is no statutory processing time.

• § Section 26 of the Federal Immission Control Act (BImSchG)
• § Section 28 of the Federal Immission Control Act (BImSchG)
• § Section 31 Ordinance on Medium-Sized Combustion, Gas Turbine and Internal Combustion Engine Plants (44th BImSchV)
• § 1 State ordinance on responsibilities in the field of immission control (ImSchZuVO)
• § 2 State ordinance on responsibilities in the field of immission control (ImSchZuVO)
• § Section 26 of the Federal Immission Control Act (BImSchG)
• § Section 28 of the Federal Immission Control Act (BImSchG)
• § Section 31 Ordinance on Medium-Sized Combustion, Gas Turbine and Internal Combustion Engine Plants (44th BImSchV)

The administrative service is a real act against which no legal remedy is possible.

• The content of the measurement report must comply with Annex A of Guideline VDI 4220 Sheet 2 (2018 edition).
• If you do not submit the measurement report or the certificate, or do not submit it correctly, completely or on time, you are committing an administrative offense that can be punished with a fine.

18.08.2023